4 2 New Energy Battery Cabinet

Where do I install a line-up and match Battery Cabinet?

Line-up-and-match battery cabinets are installed adjacent to the UPS. The recommended installation location is on the right side of the UPS cabinet as viewed from the front of the cabinet. See Figure 2 for line-up-and-match configuration view. Figure 2. Eaton 93PM 50 kW or 100 kW UPS and Two 93PM Integrated Battery Cabinets

Where is the battery cabinet located?

The battery cabinet may be located to either the right or left of the UPS cabinet. The recommended location is to the right of the UPS cabinet. This procedure assumes the battery cabinet is located to the right of the UPS cabinet. 15.

Can a battery cabinet be connected to an ups?

Each battery cabinet will be directly connected to the UPS and not daisy-chained between cabinets. Standalone IBC installations with three or four IBCs require a customer supplied external tie point and circuit breaker or disconnect between the IBCs and the UPS. Up to four IBCs can be installed in a standalone configuration.

Can You Lay tools on top of battery cabinets?

Do not lay tools or metal parts on top of batteries or battery cabinets. Refer to Chapter 3 Installation Plan and Unpacking for cabinet dimensions and weight, wiring and terminal data, and installation notes. Do not tilt the cabinets more than 10° during installation. Failure to follow these instructions may result in severe injury or death.

What temperature is a battery cabinet rated for?

The battery cabinet is rated for operation in up to a 40°C (104°F) ambient temperature. NOTE Emergency lighting and power equipment battery cabinets (UL924) are rated for operation in a 20°–30°C (68°–86°F) temperature environment. The batteries are rated for a 25°C (77°F) ambient temperature to extend their useful life.

How do you wire a battery cabinet?

Route the battery cabinet ground wiring from the UPS through the top of the IBC to the wiring channel on the left side of the IBC (see Figure 13). Route the wiring along the wiring channel to the IBC ground terminal block. See Figure 14 for terminal location. Secure the ground wiring to the wire tie anchors (see Figure 15) using Zip ties.